Studio Laser Cutters

Laser Cutters on the 4th -7th Floors:

A wide array of materials can be cut on the lasers cutters, but not everything can or should be cut with them.

DO NOT cut the following on these laser cutters:

Glass/Ceramics
Stone/Cement
Metals
PVC
 

If you are unsure, about cutting a specific material, please see an Advanced Technology staff member.

Rules of Operation - Failure to follow these rules can result in disciplinary action and can lead to extended loss of access to this equipment.

High Risk of Fire - Do not leave this machine unattended while cutting for ANY reason. If you have to leave, pause cutting by lifting the lid to the laser cutter.

The laser cutters are available from 8:00AM to Midnight, 7 days a week.

Wait several minutes before opening the laser cutter lid when cutting plastics. This gives enough time for the exhaust system to remove all unpleasant gases.

Do not stare directly at the laser cutter beam while cutting. If you stare directly at the laser cutter beam for any period of time, it can cause retinal damage to your eyes.

Avoid repeated visible flames while cutting. If you see repeated flare-ups while cutting, stop the laser cutter and adjust the cut settings, increasing the speed
and/or decreasing the power.

Do not cut with a knife on top of the laser cutters. Please use the provided cutting tables in the room.

If your workpiece is on fire, there is a fire extinguisher immediately outside each laser cutter room. Please open the laser cutter, exit the laser cutter room, and pull the nearest fire alarm before attempting to extinguish your workpiece.